Quality Equipment Supplier Stainless Steel Manual Hand Crank Winches

Manual self-locking winch is an equipment that relies on manpower to continuously rotate the rocker arm for indexing. The rocker arm drives the wheel drum through gears and rolls the wire rope in or out, and the twisted winch has automatic braking function to ensure the application safety of the winch.When the winch wire rope is loaded and the wheel drum is stationary, the brake works automatically.

1. [Install the winch]Open the package, take out the winch, spin out the hexagon nut at the end of the gear shaft, and remove the gasket.Install the rocker arm handle outward on the gear shaft, place the gasket and tighten the hexagonal cap.

2. [Install steel wire rope] Wire rope is installed on the winch wheel drum, and the steel wire rope end has been specially installed with a hook.If you need to replace the wire rope, rotate the rocker arm counterclockwise to drive the wheel drum, another person will be the wire rope as appropriate traction, you can take out the wire rope.

3. On the base of the winch is a triangular movable installation hole. If the matching installation platform is customized, the winch can be quickly installed on the platform and quickly recovered.

1. Winch products are strictly prohibited to lift or carry people.

2. Winch is a strict load product and overload is strictly prohibited.

3. It is strictly prohibited to be used for an instant recoil environment.

4. Before working, please check whether the rotation direction of the winch is correct.

5. When the winch is working, never contact the wire rope, wheel drum and gear plate.When working, it is best to cover a soft fabric on the wire rope to prevent the wire rope from suddenly breaking the wire rope because of the huge retraction stress.

6. When working, at least five laps of wire rope on the drum so that the wire rope will not slip.

7. When working, the wire rope should be kept vertical to the drum to prevent the wire rope from wearing on the edge of the drum.

8. When pulling the load, it is recommended to use a moving pulley to relieve the hand force.

9. If the wire rope is damaged (such as burr or crease), a new winch special wire rope shall be replaced immediately.

10. Please ensure that the wire rope is wrapped tightly and orderly, not loose or knot to avoid breaking and ensure safe operation.

11. Please do not use the winch rope to tighten the trailer.Bound belt or tied rope must be used to ensure the safety of the trailer in use.

12. Please do not use your own hook to circle the rope. You should use the ribbon for traction work.Using the rope with its own hook will produce incalculable stress on the rope, causing safety accidents.(See schematic diagram A)

13. Manual operation of the winch only.

    1. Regularly check whether all the parts of the winch are firm, such as loose, rust or aging, please repair and replace them in time.

    2. Check the rope before each use of winch, and work until the rope is in good condition.

    3. Before using the winch, please check whether the automatic brake device is effective and can work only if it is effective.

    4. Keep the winch surface and steel wire rope clean, and arrange and store the steel wire rope in an orderly manner.

    5. For any parts that need to replace the winch, please consult your supplier and do not replace them with any non-certified products, otherwise it will bring serious safety risks.